Pipe Cut TemplatesFeedback
SET-ON / MATCHED FABRICATION

Matched set-on templates for two parts

Enter dimensions once, then save or export matching branch and main-pipe templates.

Draft changes · save to update your task

MATCHED JOINT · Dimensions 1/7
  1. ChooseCompleted
  2. Dimensions
  3. Review
  4. Templates

Choose dimension units

Matched templates use a set-on connection: the branch rests outside the main.

Change task
SET-ON / SHARED DIMENSIONS

One joint, two parts

The branch rests on the main. The main hole follows the branch bore; these are two different profiles.

Inches accept decimals or fractions.
mm
mm
°
mm

Locate the main opening

mm
°
Leave direction blank to mark the center directly; the chosen direction is treated as 0°.Look into the selected main end: clock increases clockwise from your 0° reference. The branch leans away from that end.

Matched templates

Your joint tasks

Loading saved tasks…

Save this joint to reopen both templates together.

One set of dimensions, two matched set-on templates

Joint tasks use one set of diameters and angle for a branch-end notch and its matching main-pipe opening, with one set code on the paired PDF or DXF outputs. This workflow is for set-on joints only; use the separate main-pipe tool for set-in openings.

Assemble the two PDFs separately; never match A/B targets across the branch and main templates. Verify print scale and reference marks on both parts, then test fit the joint. Saved tasks remain in the current browser.

Start with the branch-end notch · Handle a main-pipe opening separately · Print and join template guidance